SIZE 50 x 70
DIE PLATE
EMBOSSING
BRAILLE
HOLOGRAM
HOT FOIL
TECHNICAL DATA
● Max sheet size: 740 x 530 mm (B2)
● Min sheet size: 420 x 297 mm (A3)
● Paper/carton board thickness: 80 – 500 g/m²
● Corrugated board thickness: 1.8 mm (80 pts)
● Grippers margin: 6 – 20 mm (0.25 – 0.8 in)
● Max pressure: 100 t (x 5)
● Max speed — sheets/h (multipositions/h): 1500 (~ 5000) c/h
● Automatic size adjustment: Yes
● Registration through print marks reading: Yes
● Multiposition system max.: 10
● Pressing time adjustment: Yes
● Pressing cycle repetition: Yes
● Machine dimensions: L 2.7 x W 1.5 x H 1.8 m (L106 x W60 x H70 in)
● Machine weight: 4.5 t
MACHINE FOR SMALL AND MIDDLE RUNS, CREATED FOR THE PRODUCTION OF OFFSET AND DIGITALLY PRINTED JOBS.
IT ALLOWS FAST CHANGEOVERS WITH A COST EFFECTIVE HANDLING OF DIES ANDFORMS.
INNOVATIVE DIE CUTTER
For the following die cutting operations:
Perforation – Creasing – Kiss-cut
Hot foiling – Embossing – Braille – Holograms on paper, cardboard, corrugated cardboard and plastic materials.
The unprecedented technology adopted for this machine allows working procedures that cannot be achieved with other traditional machines since it uses servo motors that control and assist all movements. The use of traditional wooden dies and clichés in combination with the new and modern technologies help carrying out different jobs.
Format changeovers are very fast, while maintaining absolute precision, quality and cost- effectiveness.
Sheet registration is guaranteed through the detection of printmarks or the edges of the sheet.
The combination of servomotors, grippers and pressing table makes it possible to process multiposition jobs: moved forward thanks to a stepping movement, the sheet is positioned several times below the pressing surface where a single cliché/die cut produces multiple parallel forms.
It is also possible to repeat the same pressure cycle several times or to stay pressed at the set
position for a pre-established lapse of time, allowing for extreme accuracy in hot foiling. The
machine is equipped also with some optionals upon request: a stripping and a blanking unit.
Multiposition
The single grippers holding bar is equipped with an adjustable positioning device.
It allows a single form or die to programme several printing or die-cutting positions on the same
sheet.
The cost of material is reduced, and time is saved in the application of patching tape and in
positioning operations.
AUTOMATIC CHANGE OF SIZE
Automatic change of size from the feeder to the delivery table.
AUTOREGISTER
It detects print marks or sheet edges, adjusting the sheet, diagonally or crosswise on the grippers.
It helps the setup of grippers margin.
PRESSING CYCLES REPETITION
Patching operations are reduced, and pressure characteristics are increased.
ADJUSTABLE PRESSING TIME
Hot foiling operations are optimized.
ADJUSTABLE GRIPPERS SPEED
Grippers speed can be set up independently of registration and die-cutting speeds.
The number of patches is reduced and the time for stripping operations decreases.